Akai MPC5000 Specifications download pdf (Page 112)

Sampling 98

03. In the 'Input' field, select CD.

The CD CONTROL page will be displayed, instead of LEVEL METER page.

04. In the 'Mode' field, select STEREO, MONO L or MONO R.

05. In the 'Time' field, set the recording time.

CD drive operation

Track

This shows the selected track number of audio CD.

Time

This shows the play time on track.

[PLAY START]

This key plays the Audio CD from the beginning of the track

[PLAY]

This key plays the Audio CD from the current time position.

[STEP]

This key will Rewind /Fast forward the Audio CD.

[BAR]

This key selects the track in Audio CD.

[STOP]

This key stops the Audio CD.

06. Select the track you wish to record with the [BAR] buttons and then press the [PLAY] button.

07. Press the [F6] (RECORD) button.

The MPC5000 will start the Audio CD recording. For the next steps, proceed as described in the 'Starting the recording' section on page 96.

Note: When CD is selected, you cannot adjust the recording level. You cannot start the recording by exceeding the

threshold level. You must start the recording by pressing the [F6] (RECORD) button.

Hint: In the LOAD page, you can load a track from the audio CD into the internal memory. For more information, see

'Saving and Loading (DISK Mode)' on page 165.

Other Features

 Monitoring feature

In the 'Monitor' field of the SAMPLE page, you can determine if you want to monitor the input signal (output the signal

from the STEREO OUT) in SAMPLE mode or not.

You can monitor the input signal. This is useful when you record sounds directly from the CD player.

OFF

You cannot monitor the input signal. For example: when you send the signal to the MPC5000 through a mixer, both the source sound

and the monitored sound may be sent to the mixer. To avoid this, you should set this to OFF.

 Peak hold/Reset peak feature

The level meter in the SAMPLE page has the peak hold feature. This is a useful feature for adjusting the signal level

during recording. Normally, the display of the level meter changes in real time according to the level of the incoming

signal. However, the peak hold displays the maximum level and keeps the level, even when the level decreases.

To reset the peak hold display, press the [F1] or [F2] (RESET PEAK) button in the SAMPLE page.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 221 222

No comments

Akai MPC5000 Specifications Page 112