Akai MPC5000 Specifications download pdf (Page 176)

Effects 162

Hi Cut Removes high frequencies from the affected output.

OutGate Sets the volume the effect output has to drop down to before the reverb effect is cut off.

Decimator

A Decimator downsamples the incoming signal by simply removing bits. The difference between decimation and

resampling is that the decimator does not use any filtering to attempt to mask or correct digital artifacts. The result is

an effect ranging from mild, to almost pure digital distortion depending on the Decim setting and the source material.

WetDry Controls the ratio of unprocessed and processed signal. At 100, the signal heard will be

100% effected.

Decim Controls the amount of decimation.

Resampler

The Resampler is similar to the decimator in that it removes bits from an incoming signal. The difference is that the

Resampler applies a complex suite of filters and anti-aliasing to attempt to retain the sound quality. This is a method

used by popular vintage samplers and sampling drum machines from the 80's. Using the Resampler effect can be

effective at achieving a "dirty" sound on drum loops, without the harshness of distortion.

WetDry Controls the ratio of unprocessed and processed signal. At 100, the signal heard will be

100% effect.

Rate Determines the sample rate the resampler will reduce the source material to.

Decim This acts the same as the Decimator shown above.

Routing Effect Buss Output to Individual Outs

The effected output of each effects buss can be routed individually to the MPC5000's individual outs. This is useful for

recording only the effected signal, or to separate the dry and affected signal for live use.

To assign a Buss output to Individual Outs, do the following:

01. From the EFFECTS Mode, select the desired Buss.

02. Select the 'Buss Output Assignment' Field as shown.

You can adjust each output with the [DATA] wheel. The following choices are

available:

L/R

The effect output will be sent to the Stereo Out.

1/2

The effect output will be sent stereo to [ASSIGNABLE MIX OUT] 1/2.

3/4

The effect output will be sent stereo to [ASSIGNABLE MIX OUT] 3/4.

5/6

The effect output will be sent stereo to [ASSIGNABLE MIX OUT] 5/6.

7/8

The effect output will be sent stereo to [ASSIGNABLE MIX OUT] 7/8.

1-8

The effect output will be sent in MONO to the corresponding [ASSIGNABLE MIX OUT] output.

Using Master Effects

The master effect is applied to the overall sound from the stereo out. You can use it separately from the four effects

busses. The effects you can use as the master effect are a 4 band equalizer and compressor. With these effects you can

add the final touches to the sound.

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 221 222

Comments to this Manuals

No comments

Akai MPC5000 Specifications Page 176

Comments to this Manuals

Related products and manuals for Musical Instruments Akai MPC5000