195
02. Select the MUTE/STOP OF ONE-SHOT SAMPLES field, and select the desired Behavior
THROUGH
One shot samples are always played until sample end.
IMMEDIATE
One shot samples are stopped immediately when pressing stop or muting the pad.
Setting the ADAT Digital Output
Normally, the ADAT output follows the chart below:
ADAT Channel Output
1 STEREO OUT L
2 STEREO OUT R
3 MIX OUT 3
4 MIX OUT 4
5 MIX OUT 5
6 MIX OUT 6
7 MIX OUT 7
8 MIX OUT 8
However, by setting the value of parameter 'ADAT Chan 1+2' to ASSIGN OUT 1&2, this will allow all eight of the
assignable mix outs to be sent through the [ADAT OUT] port.
Program Audition Note
The note played when auditioning SYNTH Programs when pressing the
PLAY button in DISK Mode can be selected in OTHER mode. Select the
'Program Audition Note' as shown on the right and select the desired
note.
Using the Footswitches
You can connect up to 2 foot switches to the MPC5000 and assign several
functions (ex. Start/Stop a sequence, etc…) to them.
01. Connect a foot switch to the MPC5000’s FOOTSWITCH jack.
02. Press the [MODE] button, and then the [PAD 9] (OTHER) to
enter OTHER mode.
03. Press the [F2] (FOOTSW) button.
This brings up the FOOTSW page, where you can make settings for the foot switch.
04. Select the function to assign to Footswitch 1 in the 'Footswitch
1' field, and the function to assign to Footswitch 2 in the 'Footswitch 2' field.
You can select the following functions.
PLAY START
The Footswitch will act the same as pressing [PLAY START] button.
Comments to this Manuals