Akai MPC1000 Operator's Manual download pdf (Page 24)

MPC 1000 v4 Operator’s Manual rev 3.5

n Slicing Samples manually

01.

02.

03.

04.

05.

06.

07.

Load a Sample and Press [MODE] + Pad 6 to enter

TRIM Mode.

Press [CHOP] (F5), to enable the Slice function. More

options become available: [AUTO] (F3), [SLICE] (F4),

[DIVIDE] (F5) and [COMBINE] (F6). For now, press

[SLICE].

The cursor jumps into the eld 'St' and 16 regions of

equal length are created (default). If you want to keep

the 16 regions as is, continue from step 05. If you want

to increase or decrease the number of regions, press

[SLICE] again. The cursor jumps into the 'Slice' eld

Move the DATA wheel left to decrease the number of

slices (min. 2) or right to increase it (max. 64), until it

ts the sample (here 7.8). Press [SLICE] again to store

the settings. To abort or start over press [CANCEL].

To ne tune the start- and endpoint of a region, move

the cursor to the 'St' or 'End' eld and turn the DATA

wheel. To select a region, move the cursor t (to Start)

or u (to End), then press the same button again (tt or

uu) to skip through the regions, then edit them.

If you want to split a region into two, press DIVIDE. To

combine two regions, simply change the start or end

point of a region with the DATA wheel until you reach

the next slice mark and cross it, or press COMBINE.

Make sure you select the direction ('St' for left and

'End' for right) of regions you want to combine!

After you've set up all your regions, press [EDIT] (F6),

select the release time of the samples and if a new

program shall be created. Press [DO IT] (F6). DONE.

TIPS:

• Use the BAR buttons (< >) in the LOCATE

section of the MPC, or [Shi] + t or u to zoom in

and out along the time line.

• You can use the [NUMERIC] Button to enter

values for start and end points to jump quickly to

a certain position.

• For quiet sections of a sample, use p or q to

zoom in and out of the volume axis.

• To undo DIVIDE or COMBINE actions, perform

the opposite operation.

• Start editing the start point of the rst slice, then

press u and jump to the end of the next region

and edit its endpoint and so forth to speed up the

editing process.

F1 F2 F3 F4 F5 F6

NOTES:::

___________________________________

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 48 49

Comments to this Manuals

No comments

Akai MPC1000 Operator's Manual Page 24

Comments to this Manuals

Related products and manuals for Musical Equipment Akai MPC1000