Akai MPC1000 Operator's Manual Page 23

  • Download
  • Add to my manuals
  • Print
  • Page
    / 49
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 22
23
MPC 1000 v4 Operator’s Manual rev 3.5
n Setting Loop Points
01.
02.
03.
04.
05.
06.
Load a Sample and Press [MODE] + Pad 6 to enter
TRIM Mode.
Press to move the cursor to the next eld and select
the audio channel you want to see in the editor. Use the
DATA wheel to select 'R' or 'L'. Press q to reach the
START eld ('St').
Turn the DATA wheel to set the start point of the section
you want to loop.
Press LOOP [F1] to enable the loop function. The area
of the sample you selected in Step 03 becomes the
looped area (indicated by a bracket above the selected
part of the sample).
Set the way the loop should behave in playback:
Loop selected area only:
If you want only the selected area inside the bracket
to be looped in playback, move the cursor to the lock
(shown left) and turn the DATA wheel right to close it.
Sustaining Loop (normal/ ping pong):
If you want to create a sustaining loop, which starts after
the whole sample has cycled through once, open the
lock (see left), set the start point, and set the playback
method for the sustaining loop: normal (indicated by an
arrow pointing right) or forwards then backwards and
so forth (ping pong loop, indicated by arrows pointing
left and right).
Enter either Program or Global Program Edit and set the
Play Mode of the sample from 'ONE SHOT' to 'NOTE
ON', so that the sample will get played back in looped
form. DONE.
JJ rened the Trim Mode with better controls, providing quicker and more intuitive ways to cut, slice, and edit
loop points of samples. Below, setting loop points and dividing samples into regions manually is explained,
as well as the newly added Auto-Chop feature. Before we go into details, have a look at the most common
controls used in Trim Mode:
 Navigate the elds above the waveform: set start and end points, select slices.
 Zoom in and out of a sample along the volume axis; jump between lines.
< > Zoom in and out of a sample along the time line.
[SHIFT] + DATA wheel Increases speed while setting start-, end- or loop points.
1. MODE + [PAD 7]
2. Highlight Sample, press
[WINDOW]
3. Set to 'Note on'
4. Press Close [F 4]
1. MODE + [PAD 11]
2. Move Cursor to 'Play
Mode' column.
3. Change Setting to 'Note
On'
F1 F2 F3 F4 F5 F6
Set start point...
...enable 'LOOP ON'...
...select Loop type...
...set Loop Mode...
...enable 'NOTE ON'.
Chapter 5: Updated Sample Editor (Trim Mode)
Page view 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 48 49

Comments to this Manuals

No comments