Akai MPC1000 Operator's Manual Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 49
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
20
MPC 1000 v4 Operator’s Manual rev 3.5
n FILTER Page: Amp Envelope
01.
02.
03.
Press [MODE] + Pad 11 to enter GLOBAL PROGRAM
EDIT Mode, then 'FILTER' (F2).
Set / change the following parameters...
ATK changes the Attack Time of a sample.
DCY changes the Decay Time of a sample.
MODE sets the way the Amp Envelope should be
applied to a sample; from the beginning
(START) or from the end of a sample (END).
Press [WINDOW] in any of these elds to enter the Amp
Envelope Screen, which displays Attack, Decay and
Velocity settings graphically (see page 69 of the original
AKAI manual v.2).
TIP: Utilize the WHOLE function to quickly apply
settings to all pads. Hold SHIFT while turning the
DATA wheel to increase the change of values by 10
times.
01.
02.
03.
Press [MODE] + Pad 11 to enter GLOBAL PROGRAM
EDIT Mode, then 'FILTER' (F2).
Move the cursor to the FILTER Section and set / change
the following parameters...
FLT1/2: Select the type of lter(s) you want to apply to
a sample:
LPF = Low Pass Filter
BPF = Band Pass Filter
HPF = High Pass Filter
LP2 = Low Pass Filter 2
FRQ 1/2: adjust the frequency / response of the applied
lter(s).
RES 1/2: adjust the resonance level of a lter.
Press [WINDOW] in either of these elds to visualize the
settings of the Filter Envelope and show more options
(see page 70 of the original AKAI manual v.2).
n FILTER Page: Filter Envelope
J
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 48 49

Comments to this Manuals

No comments