Akai MPC 60 Operator's Manual download pdf (Page 42)

Chapter 3: Recording Sequences

Page 36

================ Locate ===============A

Hit softkeys or LOCATE to go to markers:

Marker A: 001.01.00

Marker B: 001.01.00

Marker C: 001.01.00

===== Now:001.01.00 (00:00:00:00) ======

There are three sequence position markers, labeled A, B, and C.

Pressing SOFT KEY 1, 2 ,or 3 causes the MPC60 to move immediately

to the location shown in either marker A, B, or C, respectively, and the

Play/Record screen to be redisplayed. Pressing SOFT KEY 4,

<Load'Now'>, causes the contents of the Now field to be loaded into the

marker field that currently contains the cursor. To load any of the three

markers, move the cursor to it and enter the desired bar numbers in the

bar.beat.tick format (separated by decimal points), using the numeric

keypad. If you only want to enter the bar number, type it, followed by

ENTER, and the beat and tick numbers will be reset to 01.00

automatically.

There is a faster way to use locate. While the Locate screen is showing,

press the LOCATE key again, and the MPC60 will immediately move to

the sequence location of the marker (A, B, or C) where the cursor is

currently positioned, exactly as if the SOFT KEY for that marker (SOFT

KEY 1, 2, or 3) had been pressed. Therefore, from the Play/Record

screen, “double-clicking” LOCATE will instantly move to location A, B, or

C, depending on where the cursor was last positioned in the Locate

screen.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 240 241

No comments

Akai MPC 60 Operator's Manual Page 42