Akai MPC Operator's Manual download pdf (Page 49)

Section 3: Recording sequences

the nearest 1/16 note. (This may be defeated- it is explained further

in the section "The TIMING CORRECT key").

8. Press STOP.

Note: To learn how to select a different time signature or number of bars

when creating the sequence, read section 4.3.2, "Creating a new sequence".

To turn the loop off or change the loop setting, change the LOOP field.

Note 2: To adjust the TIMING CORRECT function or turn it off,

read section 3.8, "The TIMING CORRECT key".

If you don't think it sounds as good as you intended, you may need some

practice in following the metronome. If you want to erase what you've just

recorded and start again, simply repeat steps 6 through 8 above, except this

time hold down the RECORD key and press PLAY START. In RECORD

mode, any existing notes in the track are erased

as you record new notes,

just like a tape recorder, whereas in OVERDUB mode, new notes are

merged into

the existing notes in the track.

If you only want to erase a particular drum from the sequence you just

recorded, follow these steps:

1. Press the ERASE key. The following screen will appear:

2. Press the drum pads) of the drums) you wish to erase. A 4 letter

abbreviation of the drum names) will appear on the screen.

3. Press SOFT KEY l: <Erase it>. When you press this soft key, the drum

you pressed will be erased throughout the track, then the

PLAY/RECORD screen will be re-displayed.

4. Now, you can enter OVERDUB mode again and re-record that drum

into your sequence.

The ERASE function is described in further detail in the section "The

ERASE ke

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 227 228

No comments

Akai MPC Operator's Manual Page 49