Akai MPC Operator's Manual download pdf (Page 147)

Section 6: Sampling and editing sounds

147

The transfer may take as long as a few minutes. When finished, the

previous screen status will be re-displayed. If a transmission error occurs, or

if the sample dump is cancelled by the other sampler, the dump will be

cancelled and the previous screen will be re-displayed. If you wish to cancel

the sample dump, press the <Cancel send> soft key.

NOTE: It is not necessary to press <Send> to initiate the outgoing midi

sample dump. If the MPC60 receives a "dump request" message from the

external sampler at any time, it will immediately display the "Sending midi

sample dump" message and begin sending the requested sound to the

external sampler. (The DRUM field will immediately change to display the

requested drum.) Further, if a sample dump is received while the "Receive

midi sample dump" screen is showing (described in the previous section), the

screen will immediately change to the "Send midi sample dump" screen and

begin sending the data. Also, the MPC60 responds to incoming "dump

request" messages on all channels- it doesn't matter what channel the

incoming message is sent on.

• SOFT KEY 2 - <Send/recv>:

Pressing this soft key causes the "Receive midi sample dump" screen to be

displayed, described in the previous section. Pressing it again returns to the

"Send" screen.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 227 228

No comments

Akai MPC Operator's Manual Page 147