Akai MPC Operator's Manual download pdf (Page 72)

3.13 The COUNT IN key

This function causes a single bar of metronome clicks to play before the

sequence starts playing or recording, acting as a count in or count down

before the sequence starts playing, to help you to adjust to the sequence

tempo.

To turn COUNT IN on, press the COUNT IN key (the light will go on);

to turn it off, press COUNT IN again (the light will go off).

NOTE: If the current position within the sequence is not at the start of a

bar, and PLAY is pressed (with or without RECORD or OVERDUB) while

COUNT IN is on, the sequence will start playing from the start of the

current bar (after the count in has passed). If not for this, the sequence

would begin playing in the middle of the bar after one bar of count in,

which would not make musical sense.

NOTE 2: Any keys played on the input midi keyboard while the COUNT

IN bar is playing will not be output through midi (by the MIDI SOFT

THRU function) until the COUNT IN bar has finished. For example, if you

were to play a chord towards the end of the COUNT IN bar, just slightly

before bar 1 of the sequence, the chord would sound when bar 1 started

playing, which could be easily misunderstood as a processing delay. This is

normal operation and serves as a reminder that no notes may be recorded

during the COUNT IN bar, and that any notes played during that time will

be held and recorded at the start of the sequence.

NOTE 3: The metronome normally plays on 1/4 notes. However, this

note value may be changed in the RATE field, accessed by pressing the

OTHER key.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 227 228

No comments

Akai MPC Operator's Manual Page 72