Akai MPC Operator's Manual download pdf (Page 141)

Section 6: Sampling and editing sounds

141

6.5 The Echo Mixer

This function provides an additional 32 input mono mixer specifically

intended as a send signal to a reverberation device. However, it may be used

as an auxiliary mono mix for any purpose, or as a 9th individual mix output.

To adjust the echo mixer settings, press the SOUNDS key, then type 4 to

select the ECHO MIXER option, and the following screen will be displayed:

Changing the echo mixer setting is done in the same way as with the main

stereo mixer, except without the pans - press the drum pad and turn the

DATA CONTROL. As with the stereo mixer, if SOFT KEY 1 is pressed,

the mixer changes to a mode in which the settings for all drums are changed

simultaneously. Also, If the BANK 2 light is ON, the second bank of drums

is displayed for adjustment.

The output of this mix appears at the rear panel ECHO MIX OUT jack.

There is a OUTPUT LEVEL control next to the jack to adjust the overall

level to accommodate different echo devices.

There are two echo return jacks (left and right) on the rear panel. These are

intended to be used with the stereo outputs of the echo device. These two

inputs are actually general purpose inputs to the left and right sides of the

main stereo mixer, and therefore could be used to add any two signals to

the stereo mix.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 227 228

No comments

Akai MPC Operator's Manual Page 141