Akai MPC Operator's Manual download pdf (Page 140)

2. MASTER:

In addition to the sequence tunings described above, there is also a

single set of "master" tunings, which are not stored within any one

sequence, and apply to all sequences. If MASTER is selected here,

this single master set of tunings is used. It is better to use

MASTER mode if you'd prefer the tunings to always stay where

you last set them, even after changing sequences. This set of

tunings is stored to disk when a ".SET" file is saved to disk, and

therefore whenever a ".SET" file is loaded, the tuning settings from

the disk file are loaded into the MASTER settings.

• SOFT KEY 1 - <All=0>:

Pressing this soft key resets all tunings to 0.

NOTE: The settings in this screen are added to the other tuning settings in

the EDIT A SOUND and the STEP EDIT screens. For example, a

TUNING setting of "+ 10" (in the EDIT A SOUND screen), a TUNE

DRUMS setting of "-6", and a Step edit TUN setting of "-20" would

produce a final tuning for the note of -16 ("+10" plus "-6" plus "-20" _

"-16"). However, the MPC60 automatically prevents the final added tuning

from being higher than +6 semitones (+60) or below -12 semitones (-120).

If the added tuning exceeds +60, the sound plays at +60; if the added tuning

is lower than -120, the MPC60 plays -120.

140

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 227 228

No comments

Akai MPC Operator's Manual Page 140