Akai MPC Operator's Manual download pdf (Page 208)

of this field. If only one ME-35T is being used, this should be set

to "1".

• UNIT CH: This field selects the midi channel over which the

selected ME-35T (unit 1 or 2) receives its data. This should be

set to the same midi channel as the selected ME35T unit is set to

receive on. Because the ME-35T is set to receive on channel 1

when shipped from the factory, this field would normally be set

also to 1.

• INPUT: This field selects which of the 8 trigger inputs of the

selected unit is currently active for editing. The settings of the 8

fields below refer only to the input number displayed in this

field.

• NOTE: This field selects the note number which will be output

when the displayed input is triggered. The MPC60 drum which

is currently assigned to that note number (in the ASSIGN

INCOMING NOTES TO DRUMS screen) is displayed to the

right of the note number in parentheses.

SENSITIVITY: This is the input sensitivity. Adjust this until only

the hardest strike of the pad causes the overload LED on the

front of the ME-35T to flash on. The range is from 0 to 127.

TRIGGER: This is the trigger threshold. Only notes with

velocity values above this threshold will be sent from the

ME-35T. The range is from 0 to 127.

CAPTURE TIME: This parameter sets the amount of time the

ME-35T uses to determine the note velocity, in milliseconds.

This setting is a compromise between response time and

accuracy of dynamics- the faster the response, the less accurate

the dynamics. The range is from 0 to 31.

RECOVERY TIME: This is the amount of time, in milliseconds,

following a trigger during which further triggers are prevented. It

prevents false double triggering because of bounce of the stick

on the pad. Too long a time will limit the maximum rate of drum

roll. The range is from 0 to 31.

`ON' TIME: This sets the delay between sending the "Note on"

and the subsequent "Note off' command, in increments of

1/100 second. For the MPC60, this should be set to "0". The

range is from 0 to 4095.

CURVE: This parameter selects one of 8 dynamic curves that

relate strike dynamics to midi velocity. Curves 1 through 4

work best with synthesizers using logarithmic

208

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 227 228

No comments

Akai MPC Operator's Manual Page 208