Akai MPC Operator's Manual download pdf (Page 190)

190

2. Set the SYNC INPUT LEVEL control on the rear panel to

about halfway.

3. Press the TEMPO/SYNC key, then press the <Sync

Screen> soft key, and the sync screen will appear:

4. Set the MODE field (Sync input section) to FSK24. 5. Press the MAIN

SCREEN key. 6. Record the parts to be overdubbed into the MPC60. 7.

Rewind the tape to the point at which you started recording the sync tone. 8.

Play the tape. Once the tape reaches the point at which you started playing

the MPC60 while recording the sync tone, the MPC60 will start playing its

new parts in perfect sync. The current tempo setting is not used - tempo is

provided from the sync tone on tape. To use FSK24, you must always start

the tape from the beginning of the recording as in this example.

NOTE: If the MPC60 doesn't respond to the sync signal, try adjusting the

SYNC INPUT LEVEL control on the rear panel. Find the lowest setting at

which the MPC60 responds, then increase the level by about 1/4 turn.

To play back a "Song" (Song mode) in sync to the FSK24

signal:

To play back a "Song" in sync to the FSK24 signal, follow the above

instructions, except select the SONG MODE screen before receiving the

FSK24 signal. This way, the active song will play instead of the active

sequence.

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 227 228

No comments

Akai MPC Operator's Manual Page 190