Akai MPC4000 Operator's Manual download pdf (Page 176)

Sample mode

166

Trim/Loop page

Trimming or looping a sample

Here you can specify the points at which the sample will begin playing (start point) and

stop playing (end point), switch looping on/off, and specify the points at which looping

will start (loop start point) and end (loop end point) when looping is enabled.

To access this page........[SAMPLE] key → [F2] key (TRIM/LP)

A Sample block

B Trim block

C Waveform display ﬁeld (upper)

D Loop block

E Waveform display ﬁeld (lower)

Functions

• [F1] key (LIST)

Displays the Sample mode List page.

• [F3] key (REGION)

Displays the Sample mode Region page.

• [F4] key (Q-FX)

Displays the Quick FX popup window, where you can apply effects to a previ-

ously-recorded sample and resample it.

• [F5] key (EDIT)

Displays the Edit page, where you can edit effects.

• [F6] key (P

ALL)

Plays the sample from the beginning, regardless of the start/end/loop point settings. You

can also set these points manually while the sample plays.

Sample block

Here you can select a sample, and specify how to display and monitor it.

A Sample ﬁeld

Selects the sample that will be edited. When you move the cursor to this ﬁeld and press

the [WINDOW] key, the Sample popup window will appear.

B Sampling rate/bit ﬁeld

Indicates the sampling rate and bit depth of the sample you selected in the Sample ﬁeld.

C View ﬁeld

Select whether the waveform display will be LEFT (only the left channel), RIGHT (only

the right channel), or MIX (both channels mixed).

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 265 266

No comments

Akai MPC4000 Operator's Manual Page 176