Akai MPC4000 Operator's Manual download pdf (Page 178)

Sample mode

168

Loop block

Here you can switch loop playback on/off, and specify the points at which the loop will

start and end.

A Lp Start ﬁeld

Speciﬁes the point at which loop playback will start (loop start point), in units of one

sample.

B Lp end ﬁeld

Speciﬁes the point at which loop playback will end (loop end point). By moving the cur-

sor to END and turning the [JOG] dial, you can select how the loop end point is dis-

played.

• END.............................Number of samples from the beginning of the sample

• LENGTH.....................Number of samples from the start point

• TIME ...........................Time from the start point

C Play mode ﬁeld

Selects whether the sample will be looped, and how the sample will play. If you move the

cursor to this ﬁeld and press the [WINDOW] key, the Play Mode popup window will

appear, allowing you to set the sample playback method in greater detail.

• Play mode ﬁeld

This is the same parameter as the Play mode ﬁeld of the Loop block.

• Repeat ﬁeld

Speciﬁes the number of repeats. If this is set to HOLD, repeats will continue indeﬁ-

nitely.

• Loop type ﬁeld

Selects how playback will occur if the key is released while the loop region is playing.

You can select LOOP IN RELEASE (decay while playing the loop region) or LOOP

UNTIL RELEASE (decay while playing the sample following the loop end point).

• Direction ﬁeld

Selects the direction of loop playback. You can select FORWARDS (play repeatedly

in the forward direction from the loop start point to the loop end point) or ALTER-

NATING (play between the loop start point and loop end point, alternating between

forward and backward playback).

1 2

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 265 266

No comments

Akai MPC4000 Operator's Manual Page 178