Akai MPC 2000XL Operator's Manual download pdf (Page 203)

Chapter 13: Appendix

Page 192

Installing Memory Expansion

The MPC2000XL’s internal memory can be expanded to 32Mbytes using SIMMs. The

MPC2000XL comes with 2Meg of memory ‘hardwired’ and there are two slots in which you can

install SIMMs chips. The SIMMs board is inserted at a slight angle and then pushed back where it

clips into place. Some SIMMs boards have the memory chips mounted on both sides sometimes.

However, the boards can only be inserted one way so you shouldn’t have any problems. Be

careful not to force them into place otherwise they may snap.

SIMMs operate at different speeds. SIMMs that operate at at a speed of 70nS (nanoseconds) or

faster are recommended.

SIMMs also come in various sizes. Please note the following memory configurations that are

possible in the MPC2000XL.

* When 32M SIMMs are installed, the 2Meg on the MAIN board is ignored.

Note: Memory chips are sensitive to static electricity. Please observe the following

safety precautions:

•

Unplug the MPC2000XL before installing the board(s).

•

The SIMMs may come with a special wrist strap to discharge static electricity.

We suggest you attach the strap to the MPC2000XL’s case. If a wrist strap or

any other such accessory is not supplied, try discharging any static by touch-

ing an earthed metal object before handling the boards.

•

Always handle the memory board by its edges - avoid touching the compo-

nents on the board.

•

To minimise static electricity, avoid carpeted areas and low humidity areas.

IC-M2TC

You should take care that the IC is in the correct position when installing. Insert the IC according

to the direction of the socket.

EB16

Connect this to the J330 connector on the PC MAIN board and secure it with the provided screw.

FMX008M

Connect to the provided relay board and secure it with the provided screw.

(Note: Installation without using the RELAY board may cause damage to the FMX008M board or

MPC2000XL’s PC MAIN board.)

IB-M208P

Remove the cover on the REAR PANEL and install as shown in the illustration. Next, secure it with

the provided screws and connect the cable to the P340 connector on the PC MAIN board.

(

Note: Make sure that the IC522 and Ferrite Core (attached to the connecting cable) components

do not touch the bottom plate.)

Internal SIMMs Slot 1 SIMMs Slot 2 TOTAL

2M None None 2M

2M 16M None 18M

2M 16M 16M 32M*

2M 32M – 32M*

1 2 ... 198 199 200 201 202 203 204 205 206 207 208

Comments to this Manuals

No comments

Akai MPC 2000XL Operator's Manual Page 203

Comments to this Manuals

Related products and manuals for Software Akai MPC 2000XL