Akai CD3000XL Operator's Manual download pdf (Page 304)

APPENDIX 4

Page 298 S3000XL Operator’s Manual

INSTALLING THE FLASHROM

There are two slots into which the FlashROM can be installed and these are as follows:

POWER

SUPPLY

DISK DRIVE

EB16 socket

Flash ROM board sockets

SIMMs sockets

OUTPUT EXPANSION socket

IB304F socket

If you are installing only one board, it can be inserted into either slot. Of course, if you

install another, then it is inserted into the other slot.

No special setup or modification is required.

To install the board, first, DISCONNECT THE MAINS. Switching the S3000XL off is not

enough and you risk electric shock if the mains lead is not disconnected from the mains

outlet.

Remove the top panel by unscrewing the four side screws and the small screw at the rear

of the panel. Keep the screws safe. Remove the top panel. You will see the slots where

the FlashROM is to be inserted.

Memory chips are very sensitive to static electricity and can be destroyed if they get a

burst of it. To discharge any static in your body, touch the casework.

Now carefully take the board BEING EXTREMELY CAREFUL NOT TO TOUCH ANY

COMPONENTS ON THE BOARD and insert it into one of the slots. There is only one way

it can be inserted. DO NOT FORCE THE BOARD INTO THE SLOT AS YOU MAY

DAMAGE THE DELICATE PINS. Once the board is inserted, attach it securely it to the

small bracket on the casework using the screw provided.

Now replace the lid, ensuring that the four side screws and rear panel screw are securely

fastened.

1 2 ... 299 300 301 302 303 304 305 306 307 308 309 ... 312 313

No comments

Akai CD3000XL Operator's Manual Page 304