Akai CD3000XL Operator's Manual download pdf (Page 267)

GLOBAL

S3000XL Operator’s Manual Page 261

PLAYING TAKES

There are a number of ways you can play a take within the S3000XL’s DD functions:

1 You can play a take in ANY page using the ENT/PLAY key

2 You can assign a series of takes to a SONG for sequential playback or for triggering

from MIDI

3 You can play ‘raw’ takes from within the PLAY page and this is accessed in any of the

DD pages by pressing F3 - . Pressing this soft key will give this screen display:

In the PLAY page, you may audition ‘raw’ takes using the START option selected during

the record process. The fields on this page are as follows:

This shows the selected take. You can select other takes for playback by

scrolling through them using the DATA control.

This shows the sampling rate at which the selected take was recorded. If

the take is an analogue recording, this will always show 44100Hz. If the

take was recorded digitally it will show the rate at which it was recorded (i.e.

32kHz, 44.1kHz or 48kHz). You may adjust this in the event that a take

recorded digitally was, for some reason, recorded at the wrong sampling

rate.

This allows you to set the playback rate for the selected take and may be

used like a tape machines varispeed control. Normally, this will be 00.00%

but, for special effects, you may wish to set a playback rate that is different

to the takes sampling rate. This parameter may be adjusted in real-time as

the take is playing.

This allows you to set a fade-in time for the take. The range is 0-9999

milliseconds (i.e. 0 to 10 seconds).

This allows you to set a fade-out time for the take. The range is 0-9999

milliseconds (i.e. 0-10 seconds).

This allows you to route the take to one of the four effects channels FX1,

FX2, RV3 or RV4 when the optional EB16 is installed.

This allows you to set the send level of the take to the effects channel

selected in the field.

Here, you can set the method by which a take will commence playback.

The options are:

- This will cause the take to commence playback as soon as

you press - F8.

- This will cause the take to playback when it receives the MIDI

note number set in the field described below after is pressed.

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 312 313

No comments

Akai CD3000XL Operator's Manual Page 267