Akai CD3000XL Operator's Manual download pdf (Page 276)

GLOBAL

Page 270 S3000XL Operator’s Manual

IMPORTANT NOTES ABOUT TRIGGERING TAKES FROM MIDI

When triggering takes from MIDI, if you stop the sequencer and restart it somewhere in

the middle of where a take should be playing, it will not sound. This is because it requires

the MIDI note-on to trigger it. In such circumstances, it will be necessary to ‘rewind’ the

sequencer to a point somewhere before the MIDI note to ensure that the take receives

the note on and will trigger. The same, of course, is true if you are running your sequencer

synchronised to tape and triggering takes from MIDI. If you stop the tape, you will need to

rewind it to a point before the MIDI note required to trigger the take

When a take is triggered from a MIDI note, when you stop the sequencer, assuming your

sequencer sends out a MIDI ALL NOTES OFF command, the take will stop playback. If

however, your sequencer does not issue an ALL NOTES OFF, the take will continue to

play but you may specifically stop playback from the S3000XL front panel using F8 -

STOP.

Because the S3000XL can only play one take at a time, crossfading between takes is not

possible. Also, if one take is playing while another is triggered, the new take will take

priority although please note that there will be a short gap between the one take finishing

and the next take starting.

1 2 ... 271 272 273 274 275 276 277 278 279 280 281 ... 312 313

No comments

Akai CD3000XL Operator's Manual Page 276