Akai CD3000XL Operator's Manual download pdf (Page 194)

EFFECTS EDIT

Page 188 S3000XL Operator’s Manual

MONO DELAY/ECHO EFFECTS

If you selected either of the MONO echo effects, the screen you will see is something like

this:

The parameters are:

Here, you may set a delay time of up to 700mS

This sets the amount of repeats the echo effect will have by setting how

much of the delayed output is fed back into the delay line.

NOTE: Be careful with high settings as you can cause the delay line to go

unstable and cause ‘howl around’.

This sets the high frequency damping. The HF DAMP parameter filters out

some of the high frequency components in the sound in the feedback

loop. This is to simulate the effect that in real life, each repeat of the echo

gets slightly duller as the surfaces off which the sound is bouncing absorb

some of the high frequencies. The value shown is the frequency that will

be attenuated in the feedback loop.

This selects where you will listen to the output of the delay and allows you

to set the direction of the modulation section and the echo section. You

may select POST which will give the effect of echo followed by the mod

effects or you may select PRE which will give the effect of the mod effects

followed by echo.

NOTE: When PRE is selected, you must set a value in the parameter to hear

any delay effect

NOTE REGARDING MONO ECHO EFFECTS

Please note that because the stereo mod section passes through the echo section, any

stereo mod effects you create will be ‘monofied’ when mono delay effects are selected.

To enjoy stereo modulation effects with echo, please choose the stereo delay option (see

below).

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 312 313

Akai CD3000XL Operator's Manual Page 194