Akai MPC Operator's Manual download pdf (Page 105)

MPC2500 Operator’s Manual rev 1.0

Applying filters to an

incoming signal

You can apply the internal filters to the incoming signal from

REC IN (Analog) or DIGITAL IN (Digital). You can also

control the cut-off frequency and Resonance in real-time by

using Q-Link slider/knob.

01. Press [INPUT THRU] key.

The INPUT page will be displayed.

You can also get to the INPUT page by pressing the

[F5] (INPUT) key in the MIXER mode.

Set the necessary parameter in each field while refer-

ring to the Applying effects to an incoming signal.

02. In the Type field, select the filter type.

Setting set the filter type is same as in the Filter page

while in PROGRAM mode. Refer to “Editing the

sound of a sample” in the PROGRAM mode.

Note : You cannot use the Filter Modulation with INPUT THRU.

Using Q-Link feature in

INPUT THRU mode

You can control the input level, pan, and the filter’s param-

eter ( Cut-off frequency and Resonance) in real-time by us-

ing Q-Link slider/ knob.

Note : You cannot record the real-time control of the INPUT

THRU into the sequence.

Note : In this explanation, the necessary setting on the filter and

the input level/pan for INPUT THRU mode should be entered

first. If you haven’t set any parameter for them, set them while

referring to “Applying effects to an incoming signal” and “Ap-

plying filters to an incoming signal”

01. Select SLIDER mode by pressing [MODE] key then

hitting PAD 1 (SLIDER)

02. In the Assign pad field, select IN.

Note : Only “REALTIME” will be available in the Change field.

03. In the Parameter field, adjust the desired parameter.

LEVEL : This control the input signal volume level.

CUTOFF1+2 :

This controls the cutoff frequency of both Fil-

ter 1 and Filter 2.

CUTOFF1 : This controls the cutoff frequency of Filter 1.

CUTOFF2 : This controls the cutoff frequency of Filter 2.

RESO1+2 : This controls the resonance value of both Fil-

ter 1 and Filter 2.

RESO1 : This controls the resonance value of Filter 1.

RESO2 : This controls the resonance value of Filter 2.

PAN : This control the sample’s pan position.

04. In the High range field and Low range field, set the

upper and lower limit of the slider or knobs.

The value of the controlled parameter is deter-

mined by the value set here. The value depends

on the type of the parameter selected in the Pa-

rameter field.

LEVEL : 0 –100.

This is linked to the value in Level field in the INPUT

page. If you change the slider or knob, the value will

be changed depending on the value in INPUT page.

CUTOFF1+2 / CUTOFF1 / CUTOFF 2

: -50 - +50

This value also offsets the current setting in the

INPUT page.

RESO1+2 / RESO1 / RESO2 : -50 - +50

Again, this value offsets the current setting in the

INPUT page.

Note : In the Input THRU mode, you cannot record the moving

of Q-Link in the sequence.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 135 136

Comments to this Manuals

No comments

Akai MPC Operator's Manual Page 105

Comments to this Manuals

Related products and manuals for Recording Equipment Akai MPC