Akai MFC42 Operator's Manual download pdf (Page 12)

Chapter 1 Introduction

31. LEVEL knobs (Mono/Stereo channels)

Adjusts the output level of filter module. These are used to balance the Mono/Stereo outputs.

32. LINK key

Enables to control the cut-off for both Mono and Stereo channels simultaneously. The CUTOFF

knob on Mono channel controls both channels.

The CUTOFF knob on Stereo channel is disabled when LINK is ON (LED is lit while ON).

33. INVERT key

Inverts the movement of cut-off control for Mono and Stereo channels only while LINK is ena

bled (LED is lit while ON).

34. PAN knob (Mono channel only)

Adjusts the panning of output signal from the Mono channel filter module.

35. PHASE SHIFTER key

Turns the phase shifter effect on/off. It gives sound the swirl effect/rolling effect (LED is lit while

ON). The effect is applied to both Mono and Stereo channels.

36. SPEED knob (Phase Shifter)

Adjusts the speed of phase shifter (swirling/rolling) effect.

37. DEPTH knob (Phase Shifter)

Adjusts the depth/amount of phase shifter (swirling/rolling) effect.

38. DISTORTION key

Turns the distortion effect on/off. It distorts the sound (LED is lit while ON). The effect is applied

to both Mono and Stereo channels.

The amount of distortion is adjusted by the INPUT and/or LEVEL knobs on Mono/Stereo channels.

The output level is adjusted by the OUTPUT knob.

39. OUTPUT knob (Distortion)

Adjusts the OUTPUT level of distortion effect.

40. HIGH knob (EQ)

Adjusts the level of high frequency component in OUTPUT L/R and headphones.

41. LOW knob (EQ)

Adjusts the level of low frequency component in OUTPUT L/R and headphones.

42. MAIN VOLUME knob

Adjusts the level of OUTPUT L/R.

43. PHONES LEVEL knob

Adjusts the level of headphones.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 32 33

No comments

Akai MFC42 Operator's Manual Page 12