Akai S5000 Operator's Manual download pdf (Page 278)

268 Version 1.21

APPENDIX F /

INSTALLING EXTRA MEMORY (To Service Technicians)

To install extra memory, you must remove the top of the case.

** IMPORTANT NOTE **

Consult your AKAI professional dealer regarding installation of any options (including

memory) to the S5000 or S6000. Self-servicing or user installation of memory boards

and/or options may cause malfunction of components or the instrument itself.

AKAI professional does not guarantee against the unit’s malfunction, damage or any

loss caused by self-servicing, user installation of memory and or options or improper

operation.

Remove the top of the case by undoing the four large screws on top of the case and the smaller

screw in the centre of the top of the rear panel. Looking inside the S5/6000, you will see something

like this:

Analogue Outputs

Option Slots

Voice Card Slots

SIMM Slots

Power Supply

Disk Drives

The S6000’s internal memory can be expanded to 256Mbytes. The S6000 comes with 8Mb of

memory ‘hardwired’ and there are four slots in which you can install SIMMs. Installation is fairly

simple. The SIMMs board is inserted at a slight angle and then pushed back where it clips into

place. Because SIMMs boards can differ, it is not possible to say “Install them with the components

facing the front of the S6000” or anything like that because some SIMMs boards have the memory

chips mounted on both sides sometimes. However, the boards can only be inserted one way so

you shouldn’t have any problems but be very careful not to force them into place otherwise they

may snap.

1 2 ... 273 274 275 276 277 278 279 280 281 282 283 ... 291 292

No comments

Akai S5000 Operator's Manual Page 278