Akai MPC Renaissance User's Guide download pdf (Page 113)

113

Hardware: To load pad insert effects:

1. Enter Program Mixer Mode by pressing the Prog Mix button.

2. Press F5 (Insert) to view the pads' channels' insert effect slots.

3. Use the Cursor Buttons to select the desired pad. (To show another set of 16 pads, use the Pad

Bank buttons to select another bank.)

4. Use the Data Dial or the -/+ buttons to open another page to select an effect. Click F4 (Select) to

load it, or click F3 (Back) to close the page.

5. You can repeatedly press F5 (Insert) to cycle through the four available insert effect slots. The small

squares below the tab indicate the currently selected slot.

When you select a pad insert effect, it will automatically be routed to Submix 1. If you want, you can

change where it is routed:

1. In the software, click Program Mixer tab in the Mode Tab Section.

2. Click the desired pad's channel's Route button.

3. Click the downward arrow (T) of the drop-down menu above the pad's channel's Pan knob.

4. Select any one of the following outputs: the Track Mixer, Submix 1 to 8, or Out 1,2 to Out 15,16. The

outputs that are not available in your audio hardware will be grayed out. If a loaded project has

outputs routed that do not exist on your audio hardware, these will appear in red.

Remember: The MPC Renaissance offers the following physical outputs: 1,2 (main out) and 3,4

(assignable).

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 218 219

No comments

Akai MPC Renaissance User's Guide Page 113