Akai MPC Renaissance User's Guide download pdf (Page 106)

106

The LFO modulation Destinations determine the amount of effect of the LFO has on Pitch, Filter Cutoff

frequency (Filter), Volume (Amp) and Panning (Pan).

Hardware: To edit the LFO parameters, press the F5 button (Lfo Mod). For Drum Programs, use Q-Link

Knobs Q1 – Q7 for direct access to all seven parameters. For Keygroup Programs, use Q-Link Knobs

Q5 – Q12 for direct access to all seven parameters. (Remember that a Drum Program uses different

controls than a Keygroup Program.)

Controller Mod Section (Keygroup Program Only)

This section determines the influence of additional play controllers on

various sound parameters.

Important: To use these parameters, make sure that a connected MIDI

device can send pitch bend messages as well as aftertouch and

modulation wheel data.

Pitch Bend sets the range (in semitones) of a connected MIDI keyboard's pitch-bend wheel.

Whl>LFO (Wheel to LFO) determines how much a connected MIDI keyboard's modulation wheel affects

the LFO intensity.

Aft>Filt (Aftertouch to Filter Cutoff) determines how much a connected MIDI keyboard's aftertouch data

affects the filter cutoff.

Hardware: To edit the Controller Mod parameters, press the F5 button (Lfo Mod). Use Q-Link Knobs

Q2 – Q4 for direct access of all three parameters. Remember that these parameters are available only in

Keygroup Programs.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 218 219

No comments

Akai MPC Renaissance User's Guide Page 106