Akai PDP4294LV Operations Instructions download pdf (Page 28)

BNb_-00 /llA-00esa E Z (wa±±de±) 2004.4.30 Z:bb PM Page

Your PDP can memorize and store all of the available channels for both "off-air" (antenna}

and cable channels. After the available channels are memorized, use the CH /", and CH v

buttons to scan through the channels. This eliminates the need to change channels by entering

the channel digits. There are three steps for memorizing channels: selecting a broadcast

source, memorizing the channels (automatic} and adding and deleting channels (manual}.

Before your television can begin memorizing the available channels, you must specify the type of

signal source that is connected to the PDP (i.e., an antenna or a cable system}.

Pressthe Menu button. Move the joystick up or

down to select "Channel", then press the joystick

to enter.

Ant

Auto Program

Fine Tune '_ O 1.

LNA ,_ Off

O,Scan

_} ; Move Select Menu

Move the joystick left or right to select "Ant",

...... IRC".

STD , "HRC" or

o If you are connected to an antenna, leave "Ant"

displayed, if you connected cable, move the

joystick left or right to the display the type of cable

system: "STD", "HRC", or "IRC".

(if you are not sure which type of cable system you

have, contact your cable company}.

: : STD

Auto Program

Fine Tune _ O

LNA _ Off _"

Ch Scan

!i_:i_£ii!i(ii_iii¸

Move Select Menu

Pressthe Menu button to exit.

', STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company

to identify the type of cable system that exists in your particular area.

At this point the signal source has been selected. Proceed to "Storing Channels in Memory"

(next page}.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 95 96

No comments

Akai PDP4294LV Operations Instructions Page 28