Akai EWI 4000S User Manual download pdf (Page 10)

8 EWI4000s Manual Addendum v2.3

CONTINUOUS CONTROLLER PREFERENCES FOR [HOLD] BUTTON:

1. Select ‘CC’ in the Hold Menu.

You will notice that the two LED’s under [SETUP] and [TRANS] buttons will light.

2. If you press and hold the [TRANS] button, you will see one of the following submenus:

CONTROLLER

NUMBER:

This field represents the Controller number that the

[HOLD] button will use to transmit MIDI messages. Set

this number to be the same as the Controller number on the

parameter that you wish to control.

DATA :

This field contains the value that will be transmitted b when

[HOLD] button is pressed while playing. The EWI4000s

can transmit standard MIDI values from 00-127 and values

over 100 will be displayed by the last two digits with a dot

between them.

LATCHING :

This field describes whether the [HOLD] button will

function as a toggle or a momentary button. If latching is

set to ‘ON’ then the [HOLD] button will activate (transmit

the value) when pressed and deactivate (transmit 0 as the

value) when you press it again. If latching is set to ‘OF’

the [HOLD] button will be active as long as you are

pressing it down and will deactivate when you release it.

3. While [TRANS] button is held down, you can use the [HOLD] and [OCT] buttons to go

between ‘Cn’, ‘dA”, and “LA”.

When you have chosen the parameter you want to edit, release the [TRANS] button.

4. You will see the value for that parameter displayed on the screen and you can then use

the [HOLD] and [OCT] buttons to change it.

5. Press and hold the [TRANS] button to exit the sub parameter field and go back to

selecting the sub menu pages.

6. To exit editing, press the [SETUP] button.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Akai EWI 4000S User Manual Page 10