Akai DR16 pro Operator's Manual download pdf (Page 37)

3: Setting Up the DR16pro

Page 28

Setting Up the DR16pro

Locating the DR16pro

The DR16pro should be located on a strong, level surface, with plenty of room for ventilation. If

you rack mount the DR16pro, leave at least 1U of free space above and below it.

Connecting The Power

Warning:

Before connecting to an AC receptacle, make sure that the mains voltage in your

area matches that printed on the DR16pro rear panel.

Connect the supplied power cable to the power inlet on the rear panel of the DR16pro. Connect

the other end of the power cable to an appropriate AC receptacle.

Power On/Off

To power on the DR16pro, push the POWER switch to its ON position. The DR16pro takes ap-

proximately 10 seconds to warm up before it can be used. During this time it checks the status of

any disk drives, and its version number is shown on the display. Once the DR16pro is ready for

use, the following will appear on the display:

Before powering off the DR16pro, make sure that no functions are currently in progress. If the disk

is being accessed, the “BUSY” indicator will be lit.

Warning:

Powering off the unit while the “BUSY” indicator is lit - during recording or backing

up - may destroy some data.

To power off the DR16pro, push the POWER switch to its OFF position.

The internal disk drive will automatically park its heads, for protection in transit.

ABS

1 2 3 4 5 6 7 8 9

10 11 12 13 14 15 16

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 166 167

No comments

Akai DR16 pro Operator's Manual Page 37