Akai EWI5000 User Manual download pdf (Page 30)

• CC (Continuous Controller): The Interval Button will send a MIDI Continuous

Controller (CC) message. If you select this, press the Trans Button to set additional

message parameters:

o Cn (Controller Number): This is the CC number that will be sent when you

press the Interval Button. Use the Hold Button or Interval Button to set the

CC number (01–127; values over 99 will be shown as the last two digits with a

dot between them). Match this number to the CC number of the parameter you

want to control.

o dU (Data-Up): The value that will be sent with the CC message when you

release the Interval Button. Use the Hold Button or Interval Button to set the

value (00–127; values over 99 will be shown as the last two digits with a dot

between them).

o dP (Data-Press): The value that will be sent with the CC message when you

press the Interval Button. Use the Hold Button or Interval Button to set the

value (00–127; values over 99 will be shown as the last two digits with a dot

between them).

o LA (Latching): This determines if the Interval Button acts as a latching control

or momentary control. If you select this, press and hold the Trans Button to

set additional message parameters:

 OF (Off): When you press and hold the Interval Button, the Data-Press

value will be sent. When you release the Interval Button, the Data-Up

value will be sent.

 on (On): When you press the Interval Button

, the Data-Press value will be

sent. When you press the Interval Button again, the Data-Up value will be

sent.

4. To return to Performance Mode, press the Setup Button until the display is blank.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 48 49

No comments

Akai EWI5000 User Manual Page 30