Akai S1000 Series User Manual download pdf (Page 11)

2. Operation

Using a drum kit as a multisample

This can be done using the “Convert to MultiSample” command which has been

added to the Global mode P5 (Drumkit) page menu.

Select a drum kit in the Global mode P5 (Drumkit) item DrumKit.

Press the OK button.

The selected drum sample will be usable as a multisample.

It will be added to the multisamples which are already in memory.

Of the drum kit parameters, Decay, Bottom Vel, Ex, Bypass Filter, Pan, Send 1,

Send 2, and Insert FX will be ignored.

If the Start Offset check box cannot be set for even one drum sample in the drum

kit to be converted, neither will it be possible to set the Start Offset for the multi-

sample that is created by this conversion.

If you wish to use a KSF ﬁle, Sample ﬁle, or AIFF ﬁle that was loaded as a

drum sample as a multisample, perform the conversion after creating a

drum kit.

The tuning of the drum samples will be converted into the Original Key

and Tune of the samples in the multisample. Since the original key after

conversion is limited to the range of C–1 to G9, conversion may not take

place correctly for some drum sample settings.

If the converted data is saved to disk, it will be saved as a KMP ﬁle.

Press the page menu command Convert to

MultiSample.

The dialog box at right will appear.

Use the radio buttons to select either “Use High

DrumSample” or “Use Low DrumSample” for

the drum kit that will be converted to a Multi-

Sample.

With High DrumSample, all the High drum samples will be selected (those

which sound for velocities above the Bottom Vel setting).

With Low DrumSample, all the Low drum samples will be selected (those which

sound for velocities less than the Bottom Vel setting).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

No comments

Akai S1000 Series User Manual Page 11