- 23 -
Specifications and external appearance are subject to change without notice.
TROUBLESHOOTING GUIDE
SYMPTOM CAUSE (AND REMEDY)
• Check that the AC power cord is connected.
• The region number of the disc doesn't match the region number of this Unit.
• The TV is not set to receive DVD signal output.
• The video cable is not connected.
• The TV is not turned on.
• Clean the disc.
• If video from your system has to go through your VCR to get to your TV, the copy-
protection applied to some DVD programs could affect picture quality.
• The disc is scratched.
• The DVD unit may be set to progressive scan, moreover, TV does not support
Progressive Scan component video signal. Press the SETUP button repeatedly until the
"Composite" id displayed.
• The location and orientation of the antenna are incorrect. If you use an indoor antenna,
change to an outdoor antenna.
• The TV antenna wire is too close to the unit. Separate the antenna wire of the TV set
from the unit.
• Check that the speakers and equipment are connected securely.
• Make sure that you've selected the corrected equipment on the system.
• The system is in pause mode or in Slow-motion Play mode. Press the PLAY button to
return to normal play mode.
• Fast forward or fast reverse is performed. Press the PLAY button to return to normal
play mode.
• Check the speaker settings.
• Make sure that AUDIO/VIDEO output and input connections correct.
• Adjust the speaker volume.
• This unit is too hot. Power off for 30 minutes to allow the unit to cool.
• You can use the Test tones setting to test that the speaker output is present.
(Please see Customizing the Function Settings.)
• Check that the speakers and equipment are connected securely.
• Check that the connecting cords are away from a transformer or motor, and at least 10
feet (3 meters) away from a TV set or fl uorescent light.
• Move your TV away from the audio equipment.
• The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.
• Clean the disc.
• Vibrations from the speakers are affecting the unit.
• Remove any obstacles between the remote and the unit.
• Use the remote near the unit.
• Point the remote at the remote sensor on the unit.
• Replace all the batteries in the remote with new ones.
• There is no disc inside ("No Disc" appears on the TV screen).
• Insert the disc correctly with the playback side facing down on the disc tray.
• Clean the disc.
• A non-VALID disc has been inserted. The unit and disc region number are incompatible.
• Condensation may have formed inside the unit due to a sudden change in temperature.
Wait about an hour for it to clear and try again.
• Reset the unit, press the STANDBY/ON button to turn off the unit, wait for a few seconds,
then restart the unit.
No power.
No picture.
The picture is not
clear.
No sound or only
a very low-level
sound is heard.
Severe hum or
noise is heard.
The remote control
does not function.
The disc does not
play.
The DVD door
cannot open.
Comments to this Manuals