Akai S5000 User Manual download pdf (Page 6)

Temporarily remove bracket by un-screwing the 5 screws shown in the

next picture. This is necessary to place ribbon cable between chassis

and bracket, that connects ide reader to the scsi/ide board. Take the

card reader and insert thru open slot and position so that it is flush with

front panel surface.

Place bracket back, but do not screw back in place just yet. Position 40

pin ribbon cable (flat) between screw holes and securely tighten

screws. Follow the steps as shown in the picture below.

The 40 pin flat ribbon connects the card reader to the scsi/ide reader

that will be located on the other sode of the chassis wall. This is the

reason why the ribbon was placed between the chassis and the bracket.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Akai S5000 User Manual Page 6