Akai CT-S21MTD-E3 Service Manual Page 35

  • Download
  • Add to my manuals
  • Print
  • Page
    / 72
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 34
Block Diagram
Operating Temperature................... -55°C to +125°C
Storage Temperature...................... -65°C to +150°C
Voltage on Any Pin
with Respect to Ground ..................... -0.1V to +7.0V
Maximum Operating Voltage ........................... 6.25V
DC Output Current......................................... 5.0 mA
*NOTICE: Stresses beyond those listed under “Absolute Maxi-
mum Ratings” may cause permanent damage to the device.
This is a stress rating only and functional operation of the
device at these or any other conditions beyond those indi-
cated in the operational sections of this specification is not
implied. Exposure to absolute maximum rating conditions
for extended periods may affect device reliability.
Absolute Maximum Ratings*
Pin Description
SERIAL CLOCK (SCL): The SCL input is used to positive
edge clock data into each E
2
PROM device and negative
edge clock data out of each device.
SERIAL DATA (SDA): The SDA pin is bidirectional for se-
rial data transfer. This pin is open-drain driven and may be
wire-ORed with any number of other open-drain or open
collector devices.
DEVICE/PAGE ADDRESSES (A2, A1, A0): The A2, A1
and A0 pins are device address inputs that are hard wired
for the AT24C01A and the AT24C02. As many as eight
1K/2K devices may be addressed on a single bus system
(device addressing is discussed in detail under the Device
Addressing section).
The AT24C04 uses the A2 and A1 inputs for hard wire
addressing and a total of four 4K devices may be ad-
dressed on a single bus system. The A0 pin is a no con-
nect.
The AT24C08 only uses the A2 input for hardwire ad-
dressing and a total of two 8K devices may be addressed
on a single bus system. The A0 and A1 pins are no con-
nects.
The AT24C16 does not use the device address pins which
limits the number of devices on a single bus to one. The
A0, A1 and A2 pins are no connects.
(continued)
2-26 AT24C01A/02/04/08/16
Page view 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 71 72

Comments to this Manuals

No comments