Akai MPC 60 Operator's Manual download pdf (Page 172)

Chapter 9: Saving and Loading From Disk

Page 166

active disk device, either the floppy drive or one of the hard disk

partitions. It is for display only and cannot be edited. To change from

floppy disk to hard disk or vice versa, you must press <Select disk>.

• The <Load> soft key:

Pressing this soft key loads the selected file. Instructions for loading

various file types are given in the following sections.

• The <Erase> soft key:

Press this soft key to erase the selected file from the disk. An additional

screen will appear asking you to confirm the erasure.

• The <Rename> soft key:

To rename the selected file, press this soft key. The following screen will

appear:

============ Rename a File ============A

Rename the file: FILENAME.PGM

to the new name: FILENAME

========================================

To rename the file, enter the new name in the lower field in the same

manner as you would change the Sequence Name field in the

Play/Record screen, then press the <Rename it>soft key.

• The <Select disk> soft key:

This field only appears if your MPC60 contains a Marion Systems MPC-

SCSI interface and a hard disk is connected to its SCSI port. It is used to

change the active disk device from the floppy drive to one of the hard

disk partitions or vice versa. If <Select disk> is pressed, the following

screen appears:

============== Select Disk ============A

Select disk, then press <Select it> to

return to previous screen.

Disk:SCSI DISK PART A

========================================

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 240 241

No comments

Akai MPC 60 Operator's Manual Page 172