Akai AUS-12H53R150P9 User's Guide download pdf (Page 7)

Messages

MPX8's display may show these messages to indicate its current state:

Processing

The sample is currently loading into MPX8's memory. Please wait!

Reading SD Card

MPX8 is reading your SD card. Please wait!

Save Complete

The Kit has been saved successfully.

Stop All Sounds

This message is shown after you press both Volume +

– buttons

simultaneously, stopping all samples currently playing back.

MPX8's display may show these error messages if MPX8 cannot execute a command. Use the

information below to troubleshoot the problem:

<Empty>

The sample you wanted is no longer on your SD card. Make sure the

sample is on the SD card's root directory.

Card Error

Your SD card is not FAT16-

FAT32-formatted, or your SD card is not

functioning properly. Reformat your SD card to a FAT16 or FAT32 file

system.

Card Locked

Your SD card is write-protected. Remove write protection before continuing.

Int Mem Error

MPX8's internal memory is damaged and needs to be serviced. Contact

Akai Professional's technical support.

Invalid Format

MPX8 does not support the sample's file format. Please make sure the file

is a 16-bit, mono WAVs at a sample rate of 48, 44.1, 32, 22.05, or 11.205

KHz.

Kit File Full

MPX8 cannot save another User Kit because there are already 99 User Kits

saved on your SD card. Delete enough files so there are fewer than 99 User

Kits on your SD card.

No Kit File

The KITS directory on your SD card is empty (this is where MPX8 saves

User Kits; at least one Kit file must be in this directory for MPX8 to operate

normally). Delete this directory from your SD card and insert it into MPX8

again. MPX will automatically create a new KITS folder and resume normal

operation.

No SD Card

The SD card slot is empty. Insert a card in the SD card slot.

No Sounds Found

Your SD card's root directory contains no WAV files. Make sure the

samples are on your SD card's root directory.

Not Enough Space

There is not enough space on your SD card. Delete some files from it.

Sound File Error

The sample assigned to the pad is of an invalid format or is too large.

Please make sure the file is a 16-bit, mono WAVs at a sample rate of 48,

44.1, 32, 22.05, or 11.205 KHz, and make sure only 30 MB's worth of

samples are assigned to MPX8's pads at a time.

Sound Too Large

Either the sample is larger than 30 MB or adding the sample would exceed

the 30 MB limit of MPX8's memory. Please make sure only 30 MB's worth

of samples are assigned to MPX8's pads at a time.

Also, please note that a sample's size will be rounded up when loaded

(e.g., a 2.1 MB sample on the SD card will be treated as a 3 MB sample

when it is assigned to a pad).

Restoring Default Settings

To restore MPX8's default settings, which will reset all Internal Kits to their defaults, press and hold

both Volume +/– buttons while switching MPX8's power on.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

Akai AUS-12H53R150P9 User's Guide Page 7

Comments to this Manuals