Akai AUS-12H53R150P9 User's Guide download pdf (Page 6)

To adjust the parameters of a pad:

1. Use the Select +/– buttons to highlight the desired

parameter name.

2. Use the Data Dial to adjust the parameter value.

The adjustable parameters are described below:

Tuning TUNE

The pitch adjustment of sample assigned to the pad, in

semitones. The lowest possible tuning is -4, and the highest is

4. At 0, the pad will play the sample back at its normal pitch.

Reverb REV

The amount of reverb applied to the sample assigned to the

pad. The lowest amount is 0 (no reverb), and the highest is 10

(maximum reverb).

Trigger TRIG

How the sample plays back when triggered by the pad. When

set to One-Shot (1SH), pressing the pad will play the entire

sample.

When set to Hold (HLD), pressing and holding the pad will play

the sample until you release the pad. If you are still holding the

pad when it reaches the end of the sample, it will loop back to

the beginning, looping it continuously until you release the pad.

When set to Loop (LP), pressing the pad will play the sample,

looping it continuously until you press the pad again.

Level LEV

The volume level of the sample assigned to the pad. The

quietest value is 0 (silent), and the loudest is 10.

Panning PAN

The left-right balance of the sample assigned to the pad. The

left-most value is L4, the right-most value is R4, and the center

is CTR.

MIDI Note Number MID

The MIDI note message sent out when you press the pad. The

available values are 000 – 127. This value does not affect the

sample assigned to the pad; it changes the MIDI note message

sent out MPX8's MIDI Out port and the MIDI note message

MPX8 recognizes sent into its MIDI In port.

Saving Kits

If you change the currently selected Kit (in the KIT field), you will lose any changes you have made

unless you save it first.

To save the currently selected Kit:

1. Press Select + and Volume + simultaneously. The Display will ask if you want to save the

current Kit.

2. Press the Volume + button (Yes) to save the kit or the Volume – button (No) to cancel.

Please note: Saving a kit will overwrite all the pad assignments, parameters, etc. since the last

time you saved it.

To copy and save the current Kit's settings to a new User Kit:

1. Make sure an SD card is inserted into the SD Card Slot.

2. Press Select – and Volume – simultaneously. The Display will ask if you want to save the Kit to

a new Kit.

3. Press the Volume + button (Yes) to save the kit or the Volume – button (No) to cancel. MPX8

will save the Kit to the next available User Kit number (e.g., if you have 12 User Kits already

saved on the SD card, the next User Kit will be e13).

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Comments to this Manuals

No comments

Akai AUS-12H53R150P9 User's Guide Page 6

Comments to this Manuals