Akai MPC 2000XL User Manual download pdf (Page 5)

After removing bottom cover, you will see the floppy drive or zip drive

which must be removed to make room for the internal scsi flash drive.

In the picture below, note the 2 red arrows labeled as ‘C’ and ‘D’ refer

to tabs that lock the atapi/ide connector cable to the main board.

Step 2 – Remove internal scsi drive

Gently apply downward pressure to the tabs ‘C’ and ‘D’ and you will see

the atapi/ide connector disconnect at which point you can remove by

hand. Next, pull tabs in up position. Then unplug the molex power

connector from the drive. Lastly, remove the screws (referenced by 2

red arrows ‘E’ and ‘F’) that holds the zip drive in place. The drive can

now be removed by carefully sliding

into the sampler (see yellow

arrow) and in an

upward motion until it is completely out. You can put

the drive away with the ribbon cable should you ever need it again.

1 2 3 4 5 6 7 8 9 10 ... 14 15

No comments

Akai MPC 2000XL User Manual Page 5