Akai RE32 Operator's Manual download pdf (Page 69)

Version 1.00 59

AUTOLOCATOR

CYCLE

With CYCLE switched on, the system will play repetitively between the IN/OUT points you have

marked.

This may also be used in combination with the PRE-ROLL key (see below) and the AUTO-PUNCH

function.

With PRE-ROLL switched ON, the repeat will play for a time before the IN time as set by the PRE-

ROLL. It will then play for a time after the OUT time as set by the PRE-ROLL. For example, with a

PRE-ROLL of 5 seconds, the cycle will play from 5 seconds before the IN time and for 5 seconds

after the OUT time. I.e.:

IN OUT

PRE-ROLL POST-ROLL

TOTAL CYCLE LENGTH

It is also possible to use this with the AUTO punch in/out function.

For example, with CYCLE, AUTO and PRE-ROLL on, you can automate your recordings very

conveniently. The PRE-ROLL will cause playback to commence at a set amount before the IN time

and will then play back for the same amount after the OUT time, punching in and out at the IN/OUT

times accordingly. In this way, you can set a ‘run in’ and a ‘post-roll’ to an auto punch in/out.

IN OUT

PRE-ROLL POST-ROLL

TOTAL CYCLE LENGTH

AUTO PUNCH IN/OUT

NOTE: The CYCLE function does not offer ‘seamless’ looping and there will be a small gap in

playback as the connected machines cycle back to the IN point. The exact length of the gap

depends on the IN>OUT length.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 191 192

No comments

Akai RE32 Operator's Manual Page 69