Akai RE32 Operator's Manual download pdf (Page 176)

166 Version 1.00

SYSTEM SETUP

GRAB OUT MARK - When a pulse is received, it will mark an OUT point.

RESET BIPHASE - This will reset the biphase receiver.

TOGGLE EXT.TIME - When a pulse is received, it will switch on/off the

external time source.

RECORD REHEARSE - This will switch on/off the record rehearsal

function.

PLAY TRACK - These options allow any of the playback tracks to be

switched on/off by a GPI control. The first GPI command will switch the

track on, the next will switch it off.

RECORD TRACK - These options allow any of the record tracks to be

switched on/off by a GPI control. The first GPI command will switch the

track on, the next will switch it off.

RECORD TRACK ON - These options allow any of the record tracks to

be switched on by a GPI control.

RECORD TRACK OFF - These options allow any of the record tracks to

be switched off by a GPI control.

Pressing the GPO soft key (F1) will take you to the GPO assignment page:

This page allows you to set the parameters for the General Purpose Outputs (GPOs). The

parameters are:

ACTIVE Allows you to select OFF, HIGH or LOW. OFF switches the GPO function

off. HIGH selects that the GPO is normally low (0V) and when the selected

function is activated, the output will be pulled up to the voltage at the

GPO pullup pin. When set to LOW, the GPO is pulled to 0V when the

selected function is activated.

FUNCTION A variety of functions may be applied to the GPOs. These are:

PLAYING - The GPO will change level when PLAY is activated.

STOPPED - The GPO will change level when STOP is activated.

LOCATING - The GPO will change level while locating to a timecode

position.

RECORDING - The GPO will change level when RECORD is activated.

EXT TIMECODE OK - The GPO will change level while external timecode

is being successfully received.

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 191 192

No comments

Akai RE32 Operator's Manual Page 176