Akai RE32 Operator's Manual download pdf (Page 166)

156 Version 1.00

SYSTEM SETUP

NTSC 29.97Hz (VITC in) This option is available on the DD1500 only and synchronises the

machine to an NTSC 29.97Hz house sync signal through the VITC SYNC

BNC connection. This would normally be used in Japan or America when

29.97 frames per second timecode is being used.

NTSC 30Hz (VITC in) This option is available on the DD1500 only and synchronises the

machine to an NTSC 30Hz house sync signal through the VITC SYNC

BNC connection. This would normally be used in Japan or America when

30 frames per second timecode is being used.

WORDCLOCK On the DD8 or DR16pro, this allows you to sync the machine to a

wordclock signal through the SYNC BNC connector.

On the DD1500, this option allows you to sync to a wordclock signal

through the WORDCK (A) BNC connection.

This is used with a Sony PCM1630, etc. that has a separate SDIF

wordclock output.

NOTE 1: If a wordclock sync source is selected and is being successfully received, the W/C

RCV LED above the RE32’s timecode display will illuminate. If this LED flashes, this indicates

that there is some kind of problem with the wordclock (i.e. it is not connected or the cable is

faulty, whatever). Please check your connections.

NOTE 2: Recordings made at a sample rate other than the rate of the external wordclock

source will play back at the wrong speed. For example, if the wordclock being received is

44.1kHz and you try to play back a recording made at 48kHz, the recording will play back slow.

Please make sure that you are receiving the correct wordclock rate.

AUTO DIGITAL SYNC If this field is ON, the DIGITAL SYNC automatically switches to the

selected Digital input when tracks are enabled for recording.

OFF is for use with Yamaha 02R and other digital mixing desks when

the selected machine is being used as the clock source for the desk. In

this case, the machine should not switch to digital sync when a digital

input from the desk is enabled, to prevent a sample-clock loop.

EMPHASIS This selects if the emphasis flag will be set on the digital outputs, and

also controls the de-emphasis filter on the DA option board.

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 191 192

No comments

Akai RE32 Operator's Manual Page 166