Akai S1000 Series Operator's Manual download pdf (Page 95)

Page 82

Chapter 4: Editing Sequence

COMMENT: If the sequence is set to loop to an earlier bar (in

the Play/Record screen) and the copied bars are inserted

before the loop bar, the bar number specified in the Loop

field will automatically be increased to compensate for the

insertion.

COMMENT : When copying from one sequence to another, be

careful to copy MIDI track data only to MIDI tracks and

Drum track data only to Drum tracks. Otherwise, keyboard

notes can cause drum sounds to play or vice versa.

Copying Events

This function permits the copying of all events within a specified

region of a single track to a different point in the same or another

track in the same or another sequence. In this function, only the

events from the source track are copied—no time signature or tempo

data are copied. Unlike the Copy Bars function, which inserts the

copied data into the sequence, thus increasing its overall length,

this copy function either replaces the existing events or merges the

copied data with existing events, without adding additional bars.

Therefore, in this function, the track’s overall length is unchanged

after the copy has been executed.

To use this function, select option 6 (Copy events) from the SEQ

EDIT key menu. The following screen will be displayed:

=========== Copy Events From ===========

Sequence: 1 Track: 1-Track_name

Ticks:001.01.00-001.01.00

Notes:ALL (Hit pads)

============ Copy Events To ============

Sequence: 1 Track: 1-Track_name

Mode:REPLACE Copies: 3 Start:001.01.00

<Do it>

A description of the fields and soft key follows:

• The Sequence field (in the Copy Events From section):

This is the sequence from which the data will be copied.

• The Track field (in the Copy Events From section):

This is the track from which the data will be copied. Enter a 0 here

to copy all tracks at once. If you do this, the lower Track field (in

the Copy Events To section) will be forced to 0 also, because the

destination must also be all tracks.

• The Ticks fields:

These two fields are used to set the region of the track that will be

copied from, starting at the tick specified in the leftmost field and

including all data up to (but not including) the tick specified in the

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 275 276

Comments to this Manuals

No comments

Akai S1000 Series Operator's Manual Page 95

Comments to this Manuals

Related products and manuals for Recording Equipment Akai S1000 Series