Akai S1000 Series Operator's Manual download pdf (Page 212)

Page 200

Chapter 10: Syncing to Tape and Other Devices

• The Start= field:

This is the SMPTE timecode number at which the generated

time code will start. The four parts of the field are hours,

minutes, seconds and frames. Normally, this should be set to

00:00:00:00. While the SMPTE code is being generated

(when <Start> is pressed), this field will continuously

update to show the current timecode number being output.

When <Stop> is pressed, the starting value will be

redisplayed.

• The Frames/sec field:

This field has the same function as the similarly-labeled

fields in the Tempo screen and the Sync Input section of the

Sync screen. Use it to select which of the four SMPTE modes

(30, 29.97 drop, 24 or 25) you wish to generate. Be sure to

set the proper SMPTE mode in this field before recording

the SMPTE signal to tape.

• The <Start> soft key:

Pressing this soft key starts SMPTE generation.

• The <Stop> soft key:

Pressing this soft key stops SMPTE generation.

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 275 276

No comments

Akai S1000 Series Operator's Manual Page 212