Akai S1000 Series Operator's Manual download pdf (Page 192)

Page 180

Chapter 9: Saving to and Loading from Disk

====== Load MPC60 SET or ST1 file ======

Load the file's assignments into

Program:24-Program_name

(Sounds will be added to memory.)

========================================

As the screen shows, all sounds contained in the SET file will be

separated into individual sounds and added to the sound memory.

When <Proceed> is pressed, two additional screens are pre-

sented:

========= Load V2 SET/ST1 File =========

Each soundÕs pad assignment must be

converted to a MIDI note number using

the editable table in the next screen.

To standardize note-to-instrument

assignments, use general MIDI numbers.

========================================

After pressing <Next screen>:

========= Load V2 SET/ST1 File =========

Use the same assignments for loading SEQ

or ALL files. If confused, just load it.

-------- Conversion Table ----------

MPC60 Pad:HIHT-CLSD (A01)

Becomes note:56 (Gen MIDI:COWBELL )

========================================

In MPC60 version 2 SET or ST1 files, sounds were assigned to one

of 32 pad names (HIHT-CLSD, HIHT-MEDM, HIHT-OPEN, SNR1,

SNR2 ... DR15, and DR16.) In the MPC3000, SET and ST1 files are

not used. Instead, programs are used to hold sound assignments.

But in programs, sounds are assigned to one of 64 note numbers (35-

98) instead of to pad names. Therefore, in order to load the SET or

ST1 file, these pad assignments must be converted to note number

assignments. This is done automatically when <Load file> is

pressed in the screen above. Assignments are made according to the

conversion table displayed in the lower part of the screen. The

conversion table consists of two fields:

• The MPC60 pad field:

Select one of the 32 MPC60 pad names in this field. For

convenience, the pad number is shown to the right.

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 275 276

No comments

Akai S1000 Series Operator's Manual Page 192