38
Chapter 2: Recording on the DPS16
• EQ ON/OFF (equalizer on/off)
• EQ HIGH FREQ (center frequency in the high range)
• EQ HIGH LEVEL (boost/cut amount in the high range)
• EQ MID FREQ (center frequency in the middle range)
• EQ MID LEVEL (boost/cut amount in the middle range)
• EQ MID WIDTH (band width in the middle range)
• EQ LOW FREQ (center frequency in the low range)
• EQ LOW LEVEL (boost/cut amount in the low range)
<ex.The PAN parameter is selected.>
3. Use [TRACK SELECT] keys 1–16 on the top panel to select a target TRACK MIX channel.
In the Control View page, use the [INPUT SELECT] keys (for INPUT MIX channels), [TRACK SELECT] keys
(for TRACK MIX channels), and [MASTER] key (for the master section) to select a channel to control. A
square (cursor) on the screen indicates the currently selected channel.
<ex.TRACK MIX channel 16 is selected.>
✐
TIP
:
You may also move the cursor to a graphic field for any channel, using the
[CURSOR]
key.
4. Move the cursor to the Value field and rotate the [JOG] wheel to change the parameter value.
The selected channel parameter changes its value.
5. In the same way, set the other mix parameters and the parameters for other channels.
✐
TIPS :
• You can use the transport functions and the locate function in Mixer mode in the same way as in Main
mode.
• In Mixer mode, you can use the Channel View page to display all parameters for certain channels. (See
page 70.)
• You can edit mix parameters using the six knobs in the QLMC section. (See page 75.)
Comments to this Manuals