Akai DPS16 Operator's Manual download pdf (Page 180)

168

Chapter 13: Using the Effects

TAPE ECHO

This delay effect simulates a three-head tape echo machine. You can set three delay times individually. This effect

has mono-in and mono-out; however, you can adjust the pan setting of the effect sound.

Parameter Setting range Function

1 Head 1 *1 1ms – 1500ms Adjusts the delay time of Delay 1.

2 Head 2 *2 1ms – 1500ms Adjusts the delay time of Delay 2.

3 Head 3 *3 1ms – 1500ms Adjusts the delay time of Delay 3.

4 Fdback *4 0 – 127 Adjust the amount of delay feedback.

5 HFdamp *5 20Hz – 20kHz Sets a frequency at which the higher range of the feedback sound is cut.

6 Pan *6 L63 – MID – R63 Adjusts the stereo image of the effect sound.

7 Balance +50 – 0 – –50 Adjusts the balance between the effect sound and dry sound. (Effect

sound only at a value of +50)

8 Effect ON/OFF Switches the effect sound output on and off.

REVERB>SMALL ROOM

This stereo reverb effect simulates reverberations in a small room.

Parameter Setting range Function

1 Pre-D *1 1ms – 100ms Adjusts the delay time of early reflections.

2 Time *2 0.1sec – 10sec Adjusts the time of attenuation of reverberation.

3 Diff *3 0 – 127 Adjusts the density of reverberation.

4 HFdamp *4 20Hz – 20kHz Sets a frequency at which the higher range of reverberation is cut.

5 Width *6 0 – 127 Adjusts the width and spread of the stereo image.

6 Balance +50 – 0 – –50 Adjusts the balance between the effect sound and dry sound. (Effect

sound only at a value of +50)

7 Effect ON/OFF Switches the effect sound output on and off.

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 197 198

No comments

Akai DPS16 Operator's Manual Page 180