Akai DPS16 Operator's Manual download pdf (Page 161)

149

Chapter 13: Using the Effects

5. Move the cursor to the right of the knob displayed in the Send 1 field, and adjust the Send 1 level.

• Set the level to 60 – 70 so that you can hear the reverb effects. Fine-adjust the level later while playing the

DPS16.

• Inside the DPS16, AUX buses 1–4 are physically routed to FX 1–4 respectively (except for the effects being

used as insert effects).

• As you raise the Send 1–4 parameter values, signals are sent from the corresponding TRACK MIX channels to

FX1–4 via AUX buses 1–4.

<ex. Send 1 level is set to 55.>

✐

TIP :

If you set QLMC’s “mode” to “MIXER” and “panel” to SEND, you can adjust SEND 1–4 level

settings using the QLMC (

[C1]

–

[C4]

knobs).

6. Repeat steps 3–5 to set the pre/post and send level parameters of other TRACK MIX channels.

7. Press the [MASTER] key to adjust the Send Master 1 level.

Send Master 1–4 parameters enable you to adjust the level of signals routed from AUX buses 1–4 to FX 1–4.

Leave the level to 100 (default). Fine-adjust the level later while playing the DPS16.

<ex. Send Master 1 level is set to 100.>

8. Adjust the Effect Return 1 level in the same screen.

Inside the DPS16, the outputs of FX1–4 are routed to the MASTER bus L/R. Effect Return 1–4 parameters

determine the return level (the level of the effect sound returned from FX1–4 to the MASTER bus L/R).

Leave the level to 100 (default). Fine-adjust the level later while playing the DPS16.

<ex.Effect Return 1 is set to 100.>

➸

NOTE :

Effect Return 1–4 parameters in this screen are the same as the Level fields displayed on the

Effect screen.

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 197 198

No comments

Akai DPS16 Operator's Manual Page 161