Akai DPS16 Operator's Manual download pdf (Page 127)

115

Chapter 10: Project Management (Project Mode)

➸

NOTE :

If the Region field is set to “ALL”, the entire length of the selected track from beginning to end

will be written onto the disc, even if the track contains silent parts. This length (duration) does not necessarily

match the overall length of the Project.

5. Move the cursor to the Write speed field (4) and select the writing speed.

• MAX ............................... Writes data at the fastest speed of the connected drive available within the range of x1

to x4. Writing time varies depending on the speed selected.

• SLOW (x1) .................. Writes data at normal speed. Writing takes about the same time as the recording time

indicated in the Write length field (6).

• FAST (x2) .................. Writes data at 2x speed. Writing takes about half of the recording time indicated in the

Write length field.

• (x3) ............................ Writes data at 3x speed. Writing takes about 1/3 of the recording time indicated in the

Write length field.

• (x4) ............................ Writes data at 4x speed. Writing takes about 1/4 of the recording time indicated in the

Write length field.

6. Set the Test write field (7) to ON to perform test write.

✐

TIP :

Test write is a process in which a weak laser is projected onto the disc surface to check whether any

malfunctions will occur during writing data transfer. If you have not written data to discs at all or have only

done so a few times, perform the test write process.

7. Press the [F6] ( WRITE) key.

The DPS16 displays the screen for confirming execution of writing.

8. Press the [F5] ( DO IT) key to execute writing.

• If you have set the Test write field to “ON” in step 6, the test write process starts. When the test write process

finishes, actual writing starts.

• If you have set the Test write field to “OFF”, press the [F6] ( WRITE) key to start writing.

• Press the [F1] ( CANCEL) key to cancel writing.

• When writing is completed, the DPS16 returns to the Project screen.

✐

TIP :

You can continue the writing operation to record other tracks or other Projects to the same CD-R/CD-

RW disc by repeating the procedure from step 1 as long as you do not perform the Finish process (explained

on page 117.)

4. Move the cursor to the Region field (3) and select the track region (IN-OUT/ALL) to write.

• IN-OUT ........................ Writes a region between the IN and OUT points of the track selected in step 3.

• ALL ............................... Writes the entire audio data of the track selected in step 3.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 197 198

No comments

Akai DPS16 Operator's Manual Page 127