Akai HV 10 Operator's Manual download pdf (Page 43)

マイク in / out 使用時の注意点

本機は、マイクロホン in/out 端子（XLR ジャック）のみ、Normal Bypass と

True Bypass を切り替える事が可能です。

切り替え方法は、

PROGRAM A スイッチを押しながら電源を入れると “ Normal Bypass”

PROGRAM B スイッチを押しながら電源を入れると “ True Bypass”

に設定されます。（工場出荷時は、Normal Bypass に設定。）

True Bypass とは、マイクの入力信号をダイレクトにリレースイッチで切り替

え、音質の劣化を最小限にする機能です。

しかし、信号を切り替えた時、若干のポッピングノイズが発生する事がありま

すので、レコーディング等で、曲中での切り替えが必要な場合は、Normal

Bypass の使用をお勧めします。

Notes on using MIC IN/OUT (XLR) terminals

‘Normal Bypass’ mode and ‘True Bypass’ mode can be selected only when a

XLR jack is connected with Mic. In/Out Terminal at the rear panel.

To select ‘Normal Bypass’ mode, press ‘PROGRAM A’ switch and power on

simultaneously.

To select ‘True Bypass’ mode, press ‘PROGRAM B’ switch and power on

simultaneously.

(The unit has been set with ‘Normal Bypass’ mode at factory as its default

setting).

‘True Bypass’ circuit minimizes degradation of the sound quality by

connecting directly Mic. In and Mic. Out terminals with relay switch.

However, popping noises may occur when switching ‘Bypass button’ while

‘True Bypass’ mode due to the nature of low signal level of Microphone input.

Therefore we suggest that you use ‘Normal Bypass’ mode in case you need to

switch input signal during recording at studio, etc.

1 2 ... 38 39 40 41 42 43

No comments

Akai HV 10 Operator's Manual Page 43