Akai HV 10 Operator's Manual Page 34

  • Download
  • Add to my manuals
  • Print
  • Page
    / 43
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 33
26
The MIDI receiving channels of the harmonies are as follows.
ORIGINAL > MIDI channel set at Base in MIDI SYSTEM (e.g. 01ch)
Harmony L2 > ORIGINAL + 1 channel (e.g. 02ch)
Harmony L1 > ORIGINAL + 2 channel (e.g. 03ch)
Harmony H1 > ORIGINAL + 3 channel (e.g. 04ch)
Harmony H2 > ORIGINAL + 4 channel (e.g. 05ch)
System Exclusive
The program data of the DecaBuddy can be stored onto the external sequencer and/or other MIDI
devices using the MIDI System Exclusive data. The MIDI System Exclusive data can be received at
any time regardless of the mode it is in, i.e. Play mode, Edit mode.
For the operation of transmitting the System Exclusive data, refer to the MANUAL DUMP in GLOBAL
parameter.
Reset to Factory Default
The DecaBuddy can be reset to the factory default condition.
1. Switch the unit on while holding down the < button and EXECUTE/STYLE EDIT button.
2. The screen shows [RST (<) TEST (X)]. Press the < (RST) button here.
Note: Do not press the EXECUTE/STYLE EDIT button at this time. If you did, turn the unit
off once and turn it on again as above to resume.
3. The screen now shows [RESTORE PRESETS?]. Press the EXECUTE/STYLE EDIT (YES)
button to reset. Or, press the < (NO) button to abort.
4. The screen shows [Writing…..] for a few seconds. The message [COPY COMPLETED!] will
flash when the reset is completed.
5. Switch off the unit once and turn the unit on again to resume normal operation.
Reset to Factory Default
Page view 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 42 43

Comments to this Manuals

No comments